A Loft In Denver

Dining Table – part 3

5 more pieces milled… And here’s a picture of the slip-joint I mentioned last time.

In the CNC Milling post I mentioned that it takes 19 minutes of actual milling time, plus the finish pass (which is slower), plus clamping the piece up tight in the jig, plus pulling off the milled piece, etc…  So it ends up taking 30+ minutes per piece!

Tags: cnc mill, dining table, steel

This entry was posted on November 12, 2009, 8:50 pm and is filed under Furniture. You can follow any responses to this entry through RSS 2.0. You can leave a response, or trackback from your own site.

2 Comments

• #1 by Romy on November 13, 2009 - 2:51 pm

  Quote

  

  Given what you have created already, I am sure that this is going to be a super sleek and cool table. Your place must also be looking pretty awesome!

• #2 by Romy on November 19, 2009 - 1:19 pm

  Quote

  

  I was thinking about some of the pieces you have created, especially the lighting… Have you thought of making and selling any of it? ; )